Download PDF Version:
Arcade Button Installation Guide
Arcade Button Diagram
Non-Lighted Arcade Button: Installation
- Remove white plastic switch and set aside.
- Pull red plastic peg out, then push up on white plastic switch with your thumb to remove. (see Figure 1 and Figure 2 below)
- Unscrew the nut from the body and set aside.
- Drill a 1” diameter hole (with a hole saw) for the body of the arcade button to go through.
- Place the arcade button through the 1” hole.
- Secure the arcade button by screwing the nut onto the back of the arcade button. NOTE: Screw the nut with the teeth facing the arcade button (See below)
Attach the blue cables to “COM Connector 3” and “NO Connector 2” (see diagram below).
Snap white plastic switch back in place.
- Line up Red Tab 1 with bottom hole in the white plastic switch, rotate downward.
- Line up Red Tab 2 with the second hole in plastic switch, then snap back into place. (see below)
Plug each mono audio plug from the blue cables into a StealthSwitch3 port.
Lighted Arcade Button Diagram
Lighted Arcade Button: Installation
- Twist white plastic switch counter-clockwise until you hear a “snap” and the red tab is next to the white tab (about ¼”).
Pull the white plastic switch out straight and set aside.
Unscrew the nut from the body and set aside.
- Drill a 1” diameter hole (with a hole saw) for the body of the arcade button to go through.
- Place the arcade button through the 1” hole.
- Secure the arcade button by screwing the nut onto the back of the arcade button. NOTE: Screw the nut with the teeth facing the arcade button (See below)
Attach the red cables (from the power supply) to “Light Connector 1” and “Light Connector 2” (see below) NOTE: Make sure the connectors do NOT touch each other—this will cause a short circuit.
Attach the blue cables to “COM Connector 3” and “NO Connector 2” (see diagram below).
To reconnect the white plastic switch with the rest of the arcade button, first line the black pegs from the inside of the arcade button with the white plastic switch (see figure 1 below) then twist clockwise until the red peg is touching the white peg (see figure 2 below). NOTE: Do not push the arcade button when inserting white plastic piece—it will not attach properly.
- Plug each mono audio plug from the blue cables into the StealthSwitch3 ports.
Plug the power supply into an outlet and the button(s) will light up.
NOTE: if for some reason you need to disconnect any of the cables from the arcade buttons be sure to pull from the red connector itself—NOT from the cable. (see below)
Technical Support